Foggy mirrors, peeling paint and dark spots on the ceiling all point to the same problem. A remodel is the best time to fix it.

If your bathroom mirror stays foggy, the paint keeps peeling and little dark spots keep coming back on the ceiling, the room isn’t getting rid of its moisture. A remodel is the cheapest time to fix the cause instead of repainting the symptoms.
Here’s what we look at on a bathroom job in Newtown, in the order it usually matters.
A hot shower puts a lot of water into the air. If that air can’t leave, it condenses on cold surfaces, including the inside of exterior walls and the ceiling above the shower. Over time that feeds mildew, softens drywall and peels paint.
Connecticut winters make it worse. Cold ceilings and cold attic ducts are where the steam turns back into water.
The exhaust fan does most of the work. Three things to check: its size, where it vents, and whether anyone turns it on.
Fans are rated in CFM, which is cubic feet of air per minute. A common rule is one CFM per square foot of bathroom, with a minimum of about 50. A large shower or a soaking tub needs more. Pick a fan with a low sone rating too. A fan that’s loud is a fan that gets left off.
It has to go outdoors. A fan that vents into the attic, or into a soffit, puts all that moisture into your insulation and framing. We see it often in older houses, and it’s a common cause of attic mold and ice dams.
Use smooth duct, keep the run short and straight, and insulate the duct where it passes through cold space so the moisture doesn’t condense inside it. Finish with an exterior cap that has a damper.
Put the fan on a timer switch so it keeps running for 20 to 30 minutes after the shower. A humidity-sensing switch does the same thing automatically.
Warm, damp air leaks through holes around pipes, wires and recessed lights, and condenses inside the wall or attic. While the walls are open, seal around plumbing penetrations, the shower valve wall and any ceiling fixtures. Caulking the surface after the fact doesn’t reach the leak.
Tile and grout aren’t waterproof. A shower needs a proper backer board, usually cement board, with a waterproofing membrane over it and sealed seams and corners. The membrane is what keeps water out of the wall.
Give the paint time to cure before the first shower. Painting a humid room and using it right away is a common reason it peels.
A fan can only pull in air that has somewhere to come from. An undercut at the bottom of the door, about three quarters of an inch, lets makeup air in. The fan works best near the shower, not across the room.
Ask the contractor three questions. Where does the fan vent? What’s behind the tile? How is the shower waterproofed? If you don’t get clear answers, keep looking. We’d be glad to walk through the answers for your bathroom. Call us or send the form for a free estimate.
Related: Bathroom remodeling in Newtown, CT.
We typically respond within one business day.
Your information is only used to respond to your request.
Anything else? Call (203) 519-2650 and you’ll talk to the team that does the work.
A rough rule is one CFM per square foot of floor area, with a minimum around 50 CFM. Larger showers and soaking tubs need more. Look for a quiet rating so you’ll actually use it.
No. It needs to vent outdoors. Venting into the attic puts moisture into the insulation and framing and can lead to mold.
About 20 to 30 minutes after a shower. A timer or humidity sensor makes that automatic.
No. Tile and grout let water through. A membrane behind the tile is what makes a shower waterproof.
Repairs, remodeling, additions or a new build. Call or send the form and we’ll set up a free estimate.
